Product

Omnio universal dimmer 1-channel UPD230/10
Omnio base load element GLE

Universal dimmer 1-channel UPD230/10

 

with extension input

The Omnio flush mounted multi universal dimmer 1-channel UPD230/10 with extension input is a device for dimming LED luminaires and other electrical loads. Thanks to automatic load recognition (R/L/C) the dimmer selects the right operating mode as well as the ideal dimming curve for the connected light source. Up to 50 Omnio radio transmitters can be programmed. Each transmitter can be assigned a function, for example dim with rocker, dim with push-button, staircase light, predefined dim value, step-switch (AW20), timer (AW23/24/25), soft on/off, programmable scenes or presence simulation. Non-dimmable loads are automatically switched at zero crossing. Conventional push-buttons connected to the extension input are permanently assigned the function dimming with key. Bidirectional communication, EEP D2-01-03, ARCO ready (AWAG Remote Commissioning). In addition this actuator can be used as repeater in case of range issues. Suitable for flush mounted sockets.

Art.-No. 3210 000

Manual (PDF, 450 kB)

 

The base load element GLE is required if the connected LED light cannot be switched off completely or flickers. This is usually only the case with loads smaller than four watts. The base load element is simply connected parallel to the load.

Art.-No. 3219 000

 

VIDEOS: MANUAL CONFIGURATION

D02 Dim with rocker
D03 Dim with button
Measure dimmable load
A24 Timer TimeSwitch
Adjust staircase light duration
Repeater function
Delete all transmitters
Factory settings